接口流量监测

On By 去哪儿

【配置举例】

[Quidway]acl number 3000

[Quidway-acl-adv-3000]rule 0 permit icmp  source  1.1.1.1 0 destination  2.2.2.2 0

[Quidway-acl-adv-3000]rule 5 permit icmp  source 2.2.2.2  0 destination  1.1.1.1 0

[Quidway-acl-adv-3000]quit

[Quidway]traffic classifier c1

[Quidway-classifier-huawei]if-match acl 3000

[Quidway-classifier-huawei]quit

[Quidway]traffic behavior b1

[Quidway-behavior-huawei]statistic enable

[Quidway-behavior-huawei]quit

[Quidway]traffic policy p1

[Quidway-trafficpolicy-huawei]classifier c1 behavior b1

[Quidway-trafficpolicy-huawei]quit

#在vlan或端口视图下下发策略：

[Quidway]int GigabitEthernet  1/0/5

[Quidway-GigabitEthernet1/0/5]traffic-policy p1 inbound

[Quidway-GigabitEthernet1/0/5]traffic-policy p1 outbound

[Quidway]int GigabitEthernet  1/0/6

[Quidway-GigabitEthernet1/0/5]traffic-policy p1inbound

[Quidway-GigabitEthernet1/0/5]traffic-policy p1 outbound

通过以下命令查看结果

display traffic policy statistics interface gigabitethernet 1/0/5 inbound (outbound)

display traffic policy statistics interface gigabitethernet 1/0/6 inbound (outbound)

每次查看完结果之后，建议重置一下流量统计，这样计数会清零，再重新查看，比较准确；

<HUAWEI> reset traffic policy statistics all

核心交换机的接口也可以这样配置；